Power Master CSWI

PowerMaster CSWI 2000 Swing Gate Operator

Power requirements: 115 Volts, 1 phase

Class 2 low voltage control circuit

Available horse power: 1/2 - 2hp

Maximum gate weight: 1800 LBS

Maximum cycles per hour: 45 CPH

Maximum gate width: 30 feet

Gate speed: 13 seconds from open to close

UL 325 Listed for use in Class I through IV application

Solid state control board with diagnostic LED’s to indicate all input and output functions.

External control input terminal connections for:

Radio Receiver

Push Button Control Station

Key Switches

Loop Detectors

Card Key Readers

Telephone Entry Systems, Etc.

Timer to close with 0-60 sec. Adjustment standard. Longer timer available upon request.

Maximum run timer for equipment protection (self-adjusting).

Master/Slave option with dedicated terminal connection provided.

Easy Left/Right changeover.

Time delay on reverse to insure smooth gate motion and less stress on equipment.

Spike suppressing circuitry for surge and lightning protection.

Emergency control enabling circuitry for safety with security.

Electrical dynamic brake for precise gate positioning.

Magnetic gate lock control circuitry with 115 Volt output terminals.

Integral current sensing anti-entrapment circuitry with independent opening and closing sensitivity adjustment.

External anti-entrapment circuitry with separate terminal connections for easy installation of contact and non-contact sensors.

1/2 HP., 115 Volt AC, 6 Amp., 1 Phase, instant reversing, switchless, PSC motor, with thermal overload protection and high speed ball bearings for smooth, quiet operation.

Internal On/Off power switch.

Two grounded 115 Volt AC, 15 Amp. Convenience receptacles.

NEMA 1 three-button control station included.

Mechanical Specifications:

Heavy duty #7 Ga. Steel frame providing a strong and durable unit.

Hard shell baked-on weather resistant powder coating with an attractive textured finish for years of aesthetic protection from the elements.

Timing belt primary reduction for smooth, quiet and positive operation.

Heavy duty 45:1, oil bath type gear reducer for long service and dependable operation.

Heavy duty #50 sprocket and roller chain arrangement for final drive reduction.

Heavy duty pillow block type ball bearings supporting output drive shaft and enabling extended endurance under heavy loads with low maintenance.

Drive arm easily disconnected for manual operation in case of power failure.

Easily adjustable limit switch cams for precision gate positioning.

Soft start and stop at the open and close limits of travel, due to the inherent geometry of the articulating drive arm linkage.

Pad mounted for a strong, solid installation.

OPTIONAL EQUIPMENT: (Not Included)

Radio Control.

Safety Edge (contact safety sensor).

Photo Cell (non-contact safety sensor).

Loop Detector.

Card Key Reader.

Magnetic Gate Lock.

Gear Box Heater (for cold climates).

Thermostatically Controlled Cooling Fan (for hot climates).

Interior and Exterior Control Stations:

Push Buttons

Push Button with Keyed Lockout

Key Switches

Padlockable Option to secure cover for increased tamper proof protection.

Three Second Advance Audio Warning Signal available upon request.

Slow Speed Option (18 sec. From open to close).

Super Slow Speed Option (23 sec. From open to close).

‍